HSCL 0Bxx

This section lists the HSCL 0Bxx error codes.

Note: The following error messages and recovery actions might include procedures that are not available on the DS8000® management console. If in doubt, contact the next level of support. If you are instructed to shut down the management console, then you must first verify that the customer is not currently performing DS8000 actions through the management console ESSNI connection.
Table 1. HSCL: 0Bxx attention light messages
Error code Message Recovery action
0BBB Can not get LED.
  1. Rebuild the managed system. See MAP6620 Rebuilding managed system information for details.
  2. Retry the operation.
  3. Reboot the management console and then try the task again.
  4. If the problem persists, contact your next level of support.