HSCL 7xxx

This section lists the HSCL 7xxx error codes.

Note: The following error messages and recovery actions might include procedures that are not available on the DS8000® management console. If in doubt, contact the next level of support. If you are instructed to shut down the management console, then you must first verify that the customer is not currently performing DS8000 actions through the management console ESSNI connection.
Table 1. HSCL: 7xxx error codes
Error code Message Recovery action
7001 The partition profile named {0} was not found.
  1. Rebuild the managed system. See MAP6620 Rebuilding managed system information for details.
  2. Retry the task.
  3. If the problem persists, contact your next level of support
7002 The partition named {0} was not found.
  1. Rebuild the managed system. See MAP6620 Rebuilding managed system information for details.
  2. Retry the task.
  3. If the problem persists, contact your next level of support
7003 The partition with ID {0} was not found.
  1. Rebuild the managed system. See MAP6620 Rebuilding managed system information for details.
  2. Retry the task.
  3. If the problem persists, contact your next level of support
7005 The partition was not found.
  1. Rebuild the managed system. See MAP6620 Rebuilding managed system information for details.
  2. Retry the task.
  3. If the problem persists, contact your next level of support