This section lists the codes in the 0x01xx range.
Table 1. Range 0x01xx: Socket-level connect failures
| Error code |
Message |
Recovery action |
| 0x0101 |
DNS failure. |
- The management console is
unable to resolve the host name entered for the managed system through the
domain name server. Check whether the DNS is down.
- If the failure continues, remove the managed system connection and add
it back in using the IP address.
Note: Leaving a connection in the DNS failed
state might cause performance problems for other management console connections.
|
| 0x0102 |
Connecting. |
Unable to establish network connection to the managed
system. Ensure that the managed system network is configured properly. |
| 0x0103 |
Connecting. |
- The target IP address of the managed system is refusing a connection from
the management console. Ensure
that the IP specified is a valid managed system IP and that the managed system's
network is configured properly.
- Connection refused will also occur if the service processor firewall is
configured to block this management console's
IP address. Check your managed system's network configuration setting, and
make sure the management console's
IP is not being blocked.
|
| 0x0104 |
IP unreachable. |
- Unable to establish a network connection to the managed system. Ensure
the management console and managed
system are not on either side of a firewall, or if a firewall exists, ensure
that the firewall is configured properly.
- Ensure that the managed system network is configured properly. A common
cause for this might be an invalid IP configuration on the management console (for
example, bad route tables or default gateway).
|
| 0x01FF |
Connecting. |
Unable to establish a network connection to the managed
system. Ensure that the managed system network is configured properly. |