FSPSP48

A diagnostic function detects an external processor interface problem. If replacing the FRUs previously listed in the FRU list does not fix the problem, perform the steps below.

About this task

Note: Storage complex repair actions must always be managed from the management console. To replace any FRUs identified in this procedure, use Storage Facility Management > storage facility > Exchange Parts. If the FRUs are listed in the serviceable events, select them from there.

Procedure

  1. Replace the SMP cable (P2-Cx-T1 or P2-Cx-T2) that attaches the two nodes that were called out before this procedure.
  2. Perform a slow boot. See MAP4820 Performing a slow boot of a CEC enclosure.